[svp]http://www.youtube.com/watch?v=HfbtPsSw7S0[/svp]
The fastest and easiest way to remove stuck brake rotor screws.
works every time All you need is a hammer and a screwdriver.
Never struggle with rusted brake rotors crew again.
Categories
Removing Brake Rotor Screw “Fast and Easy”
52 replies on “Removing Brake Rotor Screw “Fast and Easy””
❌️❌️❌️❌️❌️❌️❌️❌️❌️❌️?
❌️❌️❌️❌️❌️❌️❌️❌️❌️❌️👎
Should of fired both of them on the spot and got it done for free after he hit it like that
Now put the rotor on the lathe and cover up the evidence ?
Now put the rotor on the lathe and cover up the evidence 😂
New rotors all the way around.
We’ll time to turn that rotor
Those screws do nothing?
Those screws do nothing🤦
Or tap the back of the screw driver while turning it Or even hit the center around the studs. You may not have to “push” but now you gotta buy a rotor.
What if u trying to save the rotors?
He broken te break disk
skrzywisz Piaste albo uszkodzisz łożysko. . .
śrubokręt udarowy sobie kup chłopie ?
skrzywisz Piaste albo uszkodzisz łożysko. . .
śrubokręt udarowy sobie kup chłopie 😏
U can use a rubber mallet
@D Rose6000 Not in the rust belt!
Try using an impact screwdriver.
I usually Torch em and use a regular screwdriver never failed me
Bad job no good
There bad now !
heat it up make sure the bit is seated right, they come out easy
The best way too fuck disc and break pads????
The best way too fuck disc and break pads🤣🤣🤣🤣
Der beste Weg um ein Radlager zu zerstören.
Are you showing the way on how not to do it?
Or showing how to damage the wheelhub bearing, turn the brake disks?
WTF
i usually use a 50 bmg for those screws
Well if the brake rotor was not junk before you whacked on it with a hammer it is now! A couple of taps on the screws would have got the screws broken free AND saved the brake rotor.
PH2 drill bit and impact.
Being a Mechanic, I use vids like this to show my customers why the guy down the street can do it cheaper…. Impact screwdriver works best.
ouch says the wheel bearing idiots
Leave them out. They serve no purpose
Correct hammer the head and it turns left for you instead of you hammering and turning a normal metal cap screwdriver.. no good mechanic just sledges a rotor maybe he was replacing anyway but we have tools for a reason.
Or you could just use an impact like every other normal person on Terra. Using a hammer is such a waste of time.
Wheelballbearingcomerical ???
What are those screws for anyway?
RIP bearing
Fake???
Fake😵💫👎
If you do that please ? don’t touch no more cars
If you do that please 🙏 don’t touch no more cars
To hold the rotors on in the assembly line at factory. They serve no purpose afterwards
New rotor better be going in with new pads
Боль
impact screw drivers are really cool and often required in the rustbelt
hope it was going in the scrap bin ,,, cos it is now.
And new bearings
Wth you doing
Ese chalán de dónde salió
Sweet Jesus.A hammer and chisel job.
Y’all some slow mf
You’re fuckin fired, get out of my shop.
Job security, now it needs an alignment.